Settings
-
Precautions for printing in cold environments
When the ambient temperature is lower than 20 ℃ / 68℉, it is recommended that most RESIONE resins, except WW123 and C01 resins, preheat (60-80 ℃ / 140-176℉, 10 minutes) before printing. If the printer is equipped with a heater, preheat for at least 30 minutes to ensure that the resin fluidity is good before printing. In addition, it is recommended to adjust the printing parameters (increase the "bottom lift distance" and "lifting distance", increase the "rest time after retract") to cope with the printing failure caused by the increase of resin viscosity.
-
Download Settings Table
-
Download settings files that can be imported into slicers
-
CHITUBOX Basic V2 or Later
RESIONE resins settings files for the following printers:
- Anycubic printer
- Elegoo printer
- Phrozen printer
- Creality Halot printer
- Nova3d printer
- Newbie printer
- Uniformation GKtwo printer
(The above files are in zip file format, please unzip them first)
How do I import settings files to CHITUBOX Slicer?
Click here to download the guidelines
-
CHITUBOX Basic V1.9.5
RESIONE resins settings files for the following printers:
- Anycubic printer
- Elegoo printer
- Phrozen printer
- Creality Halot and LD series printer
- Epax printer
- Nova3d printer
- Peopoly printer
- QIDI printer
- Zortrax printer
- Newbie printer
- JASHNC printer
- Uniformation GKtwo printer
(The above files are in zip file format, please unzip them first)
How do I import settings files to CHITUBOX Slicer?
Click here to download the guidelines
-
Only for Anycubic Photon Mono M5s and M5s Pro
-
Supports Settings For Flexible/Elastic Resin
How do I import supports settings files to CHITUBOX Slicer?
Import the downloaded files to the CHITUBOX slicer as shown in the following figure
Important:If you are using flexible/elastic resin, we recommend setting "Angle (°)" to 0.02, which can greatly improve the success rate of printing. -